Difference between revisions of "Enable/Power peripherals"
Jump to navigation
Jump to search
Joost.Weijs (talk | contribs) |
Joost.Weijs (talk | contribs) |
||
| Line 2: | Line 2: | ||
To configure this a the script is provided: <code>/opt/take-air/OpenOC2-boot.sh</code>. | To configure this a the script is provided: <code>/opt/take-air/OpenOC2-boot.sh</code>. | ||
This script automatically gets executed during boot. | This script automatically gets executed during boot. | ||
| + | |||
| + | == Change configuration == | ||
*To disable automatic power-on of the ESP, change the line: <code>START_ESP="yes"</code> to <code>START_ESP="no"</code>. | *To disable automatic power-on of the ESP, change the line: <code>START_ESP="yes"</code> to <code>START_ESP="no"</code>. | ||
| Line 7: | Line 9: | ||
*Perform a reboot apply the change(s): | *Perform a reboot apply the change(s): | ||
*:<code>$ sudo reboot 0</code> | *:<code>$ sudo reboot 0</code> | ||
| + | |||
| + | == Bootscript status == | ||
| + | To check if the bootscript gets executed correctly, use: | ||
| + | $ systemctl status openoc2boot.service | ||
Revision as of 20:30, 31 October 2021
After installation the ESP module and Cube are enabled by default: They will be powered when booting the Jetson.
To configure this a the script is provided: /opt/take-air/OpenOC2-boot.sh.
This script automatically gets executed during boot.
Change configuration
- To disable automatic power-on of the ESP, change the line:
START_ESP="yes"toSTART_ESP="no". - Similarly, to disable automatic power-on of the Cube, change the line:
START_CUBE="yes"toSTART_CUBE="no". - Perform a reboot apply the change(s):
$ sudo reboot 0
Bootscript status
To check if the bootscript gets executed correctly, use:
$ systemctl status openoc2boot.service